Hi All,

We've been experiencing some problems with our turbine lift pumps generating low suction pressure alarms. The pumps in question are positive displacement gear pumps. They are low volume hi pressure discharge pumps. The system has a 25 micron filter prior to the pump inlet and a 75 micron strainer after the discharge. When we have had these low suction pressure incidents, the suction filters were changed out. The filters had a "goop" (nice technical term) on them that has not been completely identified. This system is known to have issues with water ingestion from the bearing steam seals. Anyone out there have a similar situation??

Maybe its just me but in my experience the strainer is normally located on the pump suction and the filter after the pump. Placing a filter before the pump requires the pump to draw the fluid thru too great a restriction and could cause cavitation. Strainers are installed to protect the pump from ingesting rocks, bugs, small rodents and such. It would seem that your system is installed in reverse of the normal order.
Your "goop" is probably related to the water contamination and is likly biological in nature. If you do not have a means of eliminating water from you lube system you should have one installed. A centrifuge, coalescer, air stripper or vacuum dehydration system should be standard equipment on all large circulating systems such as your turbine. This system should be in regular use and continuous use if you have chronic water ingression.

Has your craft been using STP for a reassembly lube? STP will collect water and hold it in suspension instead of letting it drop out to the bottom of your reservoir. We have cleaned out a semi clear sludge out of the bottom of our Turbine oil tank and contributed it to the STP we were using. We have stopped using STP for several years and the problem has went away.