PAG Vs Ester in Compressor

good question both are used mixed together and seperately. I never have heard a good reason for either other than PAG is better for compressing certain Hydrocarbons I think since it will not mix in them.

Otherwsie both give LONG >7,000 hours operation time with little or no sludge or Coke buildup.

Esters maygive better cooling due to inherent lubricity from the ester that the pure PAG will not have so perhaps for cooler running a Ester would be better.
bruce

thanks for the info Bruce381.

Badnewsbare, I've read the article in machinery lubrication before and do agree to a certain extend. However, I was told that PAG in general are not really a good lubricant except for it's better heat transfer and water solubility properties.

As I'm in contact with ester based products more, I do believe for air compressor ester are still a better option. If you're using an IR screw comp, changing to a PAG may/would reduce the discharge temp due to it's design.

Anyway, above is just my personal opinion.

Ester oils will attack most of the polymers unless they are viton based. Stick with the Sullube or Ultra Coolant. Since they do not have hydrocarbons there is no varnish to form. They are both PG fluids which in todays market are only sold in a single ISO, so no issues there.

Ester oils are harm to seal.
PAG could be used for ethene compressor, while Ester will be taken out by ethene.
PAG worked well mixed with water

Dear,
Go for PAO.it is better than PG and Ester.
PAO is more thermaly stable than PG.Again evaporation rate of Ester is very higher than PAO and PG. So that oil consumption will be very high if you go for Ester.
Exactrly grade is ISO VG 46.

MOHITOSH, INDIA

Lot of opinions on PAO,PAG and ESTER that perhaps is why most Mfg have BLENDS of about all of thease eveyone has a preference.
Me I think that ESTER,PAG blends are the best of all worlds for a screw for piston ESTER.
bruce