Noria Corporation    Forums  Hop To Forum Categories  Lubrication  Hop To Forums  Filtration and Contamination Control    Case 580 flush-out hydraulic system
Go
New
Find
Notify
Tools
Reply
  
Case 580 flush-out hydraulic system
 Login/Join
 
Level 1 - 1 to 50 posts
posted
My just purchased 89 Case 580 backhoe has a water contaminated hydraulic system. How do I get all the old fluid out of the system (lines, transmission and cylinders) and before refilling? Is there a way to drain the system without disconnecting all the lines to drain? How much water can remain in the system without harm?
 
Posts: 2 | Registered: Sun February 15 2009Reply With QuoteReport This Post
Level 1 - 1 to 50 posts
posted Hide Post
quote:
Originally posted by Clayton:
My just purchased 89 Case 580 backhoe has a water contaminated hydraulic system. How do I get all the old fluid out of the system (lines, transmission and cylinders) and before refilling? Is there a way to drain the system without disconnecting all the lines to drain? How much water can remain in the system without harm?


The hydraulic oil reservoir (oiltank) is in general very often used as a "trash can". Keep the water contaminant level as low as possible. Rust is not common with levels below 500 mg/kgs but there is many other negative effects with water contaminant at levels far below this.
When it comes to your options/solutions it is all about whats your budget. It is often common to change the oil volume 3-5 times to get rid of water contaminants -depending on what your talking about, freshwater, oilcooler coolant leakage with glycol?
Oil of same brand, dryer than the excisting lubricant, will absorb (even out) water from the oil and system until "equalized" according to fluid temperature.

There is offline filtration systems on the market that is capable of dealing with your problem. It is essential to keep the hydraulics as clean as possible. Protect the oil reservoir (with oil content) from airbore pollutants, particles, water ingress/moist by using an efficient reservoir breather. There are many proucers of such equipment. There is 0.1 micron filters in the market, efficient towards operational trouble/efforts that removes solids, water, glycol, and soft contaminants from the lub.
Then again depends on the budget.
How many liters of lub do you have in system?
Hope this helps:-)
Hans.

This message has been edited. Last edited by: Clean-Lub-Safe-Operation,
 
Posts: 3 | Location: Norway | Registered: Mon February 16 2009Reply With QuoteReport This Post
Level 1 - 1 to 50 posts
posted Hide Post
The Case 580K's reservoir holds 24 gallons (90 liters) while the total system holds approximately 30 gallons (113 liters).
I replaced seals in an outrigger cylinder a week ago, there was approximately 1/2 cup of fresh water in the cylinder and no noticeable corrosion but there was sludge on top of piston.
The oil cooler is an air coil mounted in front of the engine’s radiator. There is no chance for glycol intrusion into the system.
I live on an island, budget is tight, hydraulic fluid is expensive and disposal is a problem. This leaves me with breaking lines and draining as much of the system as possible. If this doesn’t clear it up, I’ll replace the fluid again.
Thanks for your help.
 
Posts: 2 | Registered: Sun February 15 2009Reply With QuoteReport This Post
  Powered by Social Strata  
 

Noria Corporation    Forums  Hop To Forum Categories  Lubrication  Hop To Forums  Filtration and Contamination Control    Case 580 flush-out hydraulic system


 
 

Machinery Lubrication | Reliable Plant
Resources: Oil Filter | Motor Oil | Synthetic Oil | Hydraulic Fluid | Hydraulic System Troubleshooting

© Noria Corporation. All Rights Reserved.