quote:Originally posted by Rolly Angeles:quote:Originally posted by Urja Enterprises Mumbai:
dear rolly - do visit our principal's web site - www.gtsindia.com - we are in similar business. - lets work out a synergy
Hello Urja,
By profession, i am a reliability consultant here in the Philippines, yes we are in the same nature of business. Let me know what you have in mind. You can email me at rollyangeles@rsareliability.com
As for the particle counter, most of them can be read in NAS and ISO whichever you prefer, but I prefer the ISO codes in 3 digits. What is important is that particle counter must be calibrated on MTD ISO 4/6/14.
Also, I have some training materials on Lubrication Strategy and understanding the importance of Oil Contamination Control that you might be interested upon which i developed.
Regards,
Rolly Angeles
www.rsareliability.com
Rolly,
I did access your website, primarily because I agree with your firm stand regarding the use of ISO 4406/99. However, after browsing through pages of your pdf file: “Tables on Oil Analysis”, reviewed in 2003, I am kinda disappointed. On this forum you correctly advocate use of ISO 4406/99 (measurement of >4, >6, and >14 micron particles), but the document on its first page in Table 2. refer to 5, 15, 25, 50, and 100 microns. Also, throughout the document there is no consistency as far as suggested ISO cleanliness level; it jumps from two-number codes to three-number codes. In addition, I could not find ANY note showing or noting that suggested ISO codes refer to 4406/99. If I would be you, I would clean up this document and make it more uniform throughout, because, except for the mentioning, it contains very useful info for all levels of tribology enthusiasts.