What would cause a grease with a PAO base oil and calcium sulfonate thickener to become like play dough after a few months in service?
Application is a pulp dryer where bearing housing temp is 190 to 200F and roll speed is <100 rpm.
Original Post
Read our primer articles: OEE | RCM | Lean Manufacturing | Kaizen Events | FMEA
Replies sorted oldest to newest
Have you sent a sample of it out and had a analysis done on it yet?
Could it be contamination of pulp getting into the bearings?
What grease are you using and what NGLI rating?
Could it be contamination of pulp getting into the bearings?
What grease are you using and what NGLI rating?
Hi POS,
Simply lubricate more often.
Regards,
Danny
Simply lubricate more often.
Regards,
Danny
Hi POS,
Go for Polyurea base grease with refined mineral oil.
Go for Polyurea base grease with refined mineral oil.
Calcium sulfonate normally has a complex fiber and has low water wash out < 1.5% and can work with 20% moisture .
Please check your seals & use a higher NLGI grade.Hope this helps
Please check your seals & use a higher NLGI grade.Hope this helps
